This standard is issued under the fixed designation D ; the number immediately This test method was adopted as a joint ASTM–IP standard in operator prepares and inserts the beakers (with test oil, covers, and stirrers) into the bath as per ASTM D method. The test rod assembly (includes the steel. Model is a 6 test positions agitated liquid bath conforming to ASTM D, D, D, NACE TM and other similar tests. A timer alerts the.
|Published (Last):||18 May 2005|
|PDF File Size:||6.56 Mb|
|ePub File Size:||10.83 Mb|
|Price:||Free* [*Free Regsitration Required]|
Active view current version of standard. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Clear plastic stirrers’ shield for 4 position baths. A protective cover is provided over the motor. Manual Liquid Bath for Rust Testing, 6 positions. This test method is also used for testing other oils, such as hydraulic oils and circulating oils.
Polishing device with f665 Volts. In addition, a float switch interrupts power to the heaters in the event of low asrm liquid level. The stainless steel bath has drain for easy replacement of the bath medium. C0 Standards Related Products.
Manual Liquid Bath for Rust Testing, 4 positions. Specifications subject to change without notice. It is used for specification of new oils and monitoring of in-service oils.
ASTM D Rusting Characteristics of Petroleum Products
Model is identical to Model but with only 4 test positions. Water beaker for D Part D6665, each. Horizontal disc test specimen for D, each. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. The individual stirrers are belt driven. For specific warning statements, see 7. Steel test specimen for D, each.
Rust-Preventing Characteristics of Mineral Oil – ASTM D665, D3603, D7548 | NACE TM-01-72 | IP 135
Silicone carbide paper grit 50 sheets. Work Item s – proposed revisions of this standard. Models A and B are identical to Models A and B, respectively, but with 6 test positions.
A timer alerts the operator to method critical steps requering attention.
No other units of measurement are included in this standard. Link to Active This link will always route to the current Active version of the standard. C0 Standards Related Products 1. Individual stirrers have the ability to be lifted out of the test beaker by simply loosening the knurled holding nut and lifting from the beaker.
Provision is made in the procedure for testing heavier-than-water fluids.
This test method is also used for testing other oils, such as hydraulic oils and circulating oils. A secondary high temperature limit switch prevents over heating in the event of primary controller failure.
Clear plastic stirrers’ shield for 6 position baths. A digital tachometer is zstm displaying the rotational speed of the stirrers. Holding chuck for polishing test specimen. This test method was used as a basis for Test Method D Model A is an aluminum dry bath with 4 positions. Rusting test apparatus assembly with specimens for D Fig. For specific warning statements, see 6.
For synthetic fluids, such as phosphate ester types, the plastic holder and beaker cover should be made of chemically resistant material suitable for the type of fluid tested. FTM Paddle and Shaft. A clear plastic safety guard is available as an option on the front of the apparatus protecting the operator from the rotating stirrer shafts. Link to Active This link will always route to the current Active version of asgm standard.
This test indicates how well inhibited mineral oils aid in preventing this type of rusting.
Beaker cover for D and D, each. This standard does not purport to address all of the safety concerns, if any, associated with its use.
It consists of a motor rotating the chuck at to rpm. Note 1—For synthetic fluids, such as phosphate ester types, the plastic holder and beaker cover should be made of asgm chemically resistant material, such as polytetrafluoroethylene PTFE. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Historical Version s – view previous versions of standard. The d65 of the these aluminum baths over a liquid bath is the safety with the elimination of fumes and fire hazards if using oil as the bath medium. The test beakers rest on a perforated support rack at the test specified level.
Each position is individually temperature controlled and independent of other positions. Provision is made in the procedure for testing heavier-than-water fluids.