SANS 10199 PDF

17 Apr Source: SANS [1]. The results are sometimes difficult to interpret where dry soil is un- derlaid with moist soils and where the soil. The latest Tweets from sans. (@ToyFreddy). Just give up. I did. 2 Nov SANS EPUB – SANS Protection against lightning –– Part 3: Physical damage to structures and life hazard. The design and installation of.

Author: Voodooshura Zulukinos
Country: Saudi Arabia
Language: English (Spanish)
Genre: Medical
Published (Last): 5 August 2004
Pages: 198
PDF File Size: 8.99 Mb
ePub File Size: 7.97 Mb
ISBN: 862-8-24406-703-3
Downloads: 46517
Price: Free* [*Free Regsitration Required]
Uploader: Zololl

Amdt 1 8 Protection measures against injury to living beings due to touch and step voltages The requirements of SANS apply. This does not preclude the free use, in the course of sans the standard, of necessary details such as symbols, sans size, type or grade designations.

SANS 10199:2016 (Ed. 2.02)

Approval szns Name sans lighting protection inspector: The distance from the mast to the thatch shall be not less than 1 mm. SANS The design and installation of an earth electrode. Unless exemption has been sansno extract may be reproduced, stored in a retrieval system or transmitted sans any form or by any means without prior written permission the SABS Standards Division.

NOTE The earth resistance of the electrode systems should preferably not be measured whilst the soil is wet. Approval signature Name of lightning protection inspector: Date of installation safety report: NOTE The earth resistance of the electrode systems should preferably not be measured whilst the soil is wet.

SANS EPUB DOWNLOAD

This san be done at the point where the service enters or leaves the space to be protected see annex D in SANS This document was published in March The SABS continuously strives to sans the quality of its products and services and would therefore be grateful if anyone finding an inaccuracy or ambiguity while using this standard would inform the secretary of the technical committee responsible, the identity of which can be found in the foreword. Water pipes, vent pipes, tanks, gas pipes, antennas, telephone and bell wires, burglar alarms and electrical wiring and conduit within 1 mm of the thatch shall be shielded, bonded and earthed see SANS Sans installation has its own inherent requirements, such as hazardous areas, sophisticated electronic process control, and many other factors, such sans local lightning conditions, corrosiveness of sanx and etc.

TOP Related Posts  MAZDA MIATA PERFORMANCE HANDBOOK PDF DOWNLOAD

Surge protective devices inspection: Main sams distribution board: NOTE A risk, acceptable to the user, might be present when the quantity of dangerous material is strictly limited, as in a laboratory or a small store, where the structure is sited in an isolated position, or where the structure had been specifically designed to restrict the effects of a catastrophe. If these details are to be used for any purpose other than implementation, prior written permission must be obtained.

NOTE The following abbreviations have been used: In sans circumstances the dangerous materials might be not exposed but completely encased in a metal enclosure of adequate thickness see annex D in SANS Risk assessment User-specified acceptable risk Tolerance on risk: The SABS continuously strives to improve the quality of its products and services and would therefore be grateful if anyone finding an inaccuracy or ambiguity while using this standard would inform the secretary of the technical committee responsible, the identity of which can be found in the foreword.

The results are sometimes difficult to interpret where dry soil is un- derlaid with moist soils and where the soil. ATS air-termination systems DTS down conductor termination system ETS earth-termination system In the event of an equipotential bonding bar that was replaced, proof of correct installation and reconnection of equipment to the bonding bar shall be shown.

Testing should be performed before the start of each lightning season.

Details of LPS installation installer Name: The earthing system shall be tested in accordance with SANS SANSThe design and installation of earth electrodes. Telephone wires, overhead service connections sans the electricity supply or other overhead metal wires or pipes shall not enter the structure through or close to the thatch. Railway lines, piping for gas, water, rain, steam, compressed air or any other service shall be bonded as direct as possible to the LPS earthing system.

TOP Related Posts  74926 DATASHEET PDF

Details and advice can be obtained from the Senior Manager. Protection sana lightning — Physical damage to structures and life hazard.

Details of LPS designer Name: The Centre also offers an individual updating service called INFOPLUS, which ensures that 101199 automatically receive notification regarding amendments to, and revisions of, international standards.

Amdtl 12 SANS Installations shall comply with the requirements of an isolated LPS. Risk assessment User-specified acceptable risk Tolerance on risk: Our Services In Brief. For undated references, the latest edition of the referenced document including any amendments applies. Down conductor system Material used: Approval signature Name of lighting protection inspector: Electrical and electronic systems within structures. SANS The design and installation of an earth electrode.

This shall be done at the point where the service enters or leaves the space to be protected see annex D in SANS Conductive equipment within the structure and electrical conductors should not be installed within distances to the air-termination system conductors and to down conductors shorter than the separation distance defined in 5.

In the event where the connection between the bonding bar, the Sanz and the DTS was repaired, proof of the repair by accredited personnel shall be submitted. Risk assessment User-specified acceptable risk Tolerance on risk: Date of installation safety report: